KV1S Turret 28mm for Warlord/Italeri kit от Jerry_3d

Модель
loading...
Описание Модели
3D model of deweycat
The models were repaired and checked for printability.

This is a turret only for use on the 28mm (1/56th) scale Warlord/Ilateri KV1 tank kit....Показать больше
This will be of interest for fans of the Bolt Action gaming system. The standard KV, at "regular", will cost 350 points. The KV1S (a version used in the mid war period) was lightened to allow more speed (hence the "S" in the name); in the game this model loses the "armour all round" of 10+, but also looses the "slow" rule, and cost a whopping 70 fewer points - 280 points for a regular tank with 10+ frontal armour, a medium AT gun with 2" HE, and three MMGs.
In this model I started with Bergman file and upscaled the turret, re-did the main gun barrel to be more robust, added a turret pivot to fit the Warlord model. The fit is nicely snug. It will not fall out if held upside down, but slides on without issue. It could just be my print settings, results may vary.
I have done up two versions; one with the rear turret MMG to be printed and a second with a void in place of the rear MMG, in case someone wished to use an alternate method of representing the MMG.
As always, please be careful when removing the print supports.

Printer brand:
Prusa

Printer:
i3 MK2S

Supports:
Yes

Resolution:
.1mm

Infill:
20%

Notes:
I strongly suggest supports and a raft
https://www.facebook.com/deweycatproductions
Об авторе этой модели
51 models uploaded
Подтвержденный профиль