3D model of designmaketeach
The models were repaired and checked for printability.
Which of the following nets could be folded to form a cube?
The question above
...Показать больше
challenges students to mentally convert a 2D outline into a 3D object. While a majority of students are able to intuitively answer this question, many students struggle especially in a high-stakes standardized testing environment. The Nets of a Cube - Geometry Manipulative Set allows students to explore the connection between a 2D outline and a real 3D objects. Students fold/unfold the manipulative between a flat object and a cube. Like an optical illusion, once the students makes the connection, they are able to 'see' the relationship. This math manipulative was designed based on the need of a high school geometry teacher to provide a tactile learning experience for exploring 3D figures.,
The set contains 6 nets, 3 of the nets form a cube and 3 of the nets do NOT form a cube. The set allows teachers to create physical problems sets in a variety of formats that emulate standardized test questions.
- Which of the following nets could be folded to form a cube? (4 answer multiple choice - 1 correct answer)
- Which of the following nets can NOT be folded to form a cube? (4 answer multiple choice - 1 correct answer)
- Which of the following nets could be folded to form a cube? Select all the correct answers? (6 answer multiple choice - 3 correct answers)
These foldable cubes can be used for a variety of lesson objectives including math vocabulary, properties of a platonic solid, measurement, calculation of area and volume and percent error calculations. A pdf of lesson ideas for the foldable nets of a cube is included in the downloads.
Printability: Designed for a 0.2 mm layer height. Has been printed successfully by designer in PLA/ABS on multiple machines including a Makerbot Replicator 2X. Variation of design has been printed in the wild. See instructions for printing tips.
Nets of a Cube are printed flat and then folded into shape. Only 3 of the designs can be folded into cubes (Netcubea.stl, netcubeb.stl and netcubec.stl). Can be printed with or without infill. Examples were printed with PLA. Designed for a 0.2 mm Layer height.
Note for Printing on a Makerbot Replicator 2: The print must be oriented (rotated) on the build platform so the infill lines are as perpendicular as possible to the folds. If the infill lines are parallel to the folds the folds will crack. In an earlier version of Makerware the print could be rotated to the optimal 45 degree angle to create a hinges from the threads of plastic. New version of Makerware will cause the infill to run parallel to the folds at 45 degrees. We've had success rotating the print to approximately 30 degrees.
Slic3r users have reported success with a concentric fill pattern.
Design requires tape or glue to hold the shape of a cube.
Original designs created in Tinkercad.
https://www.instagram.com/designmaketeach/
