3D model of daandruff
The models were repaired and checked for printability.
Here's a Purple Worm from DnD. I wanted to make my own design of it and make it
...Показать больше
as printer-friendly as I could. If you print a couple of extra bases, you can use them as burrow holes as well.
Printer:
Anet A8
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
10%
Notes:
Print it as two halves, your slicer should be able to care of that (otherwise, you could use MeshMixer). There's a small artifact inside of the body, but it doesn't effect the final print and doesn't make the print any harder so just ignore it ;)
