3D model of 300zxcolin
The models were repaired and checked for printability.
Hi Guys
This is the Conspirator raid rifle.
Sorry the photos are rubbish but I
...Показать больше
struggled to get it all in the frame.
Not gonna lie to you, this is a massive gun at 1.5 metres long but its as cool as hell.
The parts are quite large so if your printer is smaller than a CR10 you'll need to cut the bits smaller. Apart from that its pretty straightforward.
The barrel is a thing. It needs a 15mm PVC pipe inserted up the middle to give it enough strength. The barrel section is an odd short length so you'll need to print a few of them then join them together to get the right barrel length.
Good luck with this one, it's a beast!
Colin
https://www.facebook.com/300zxcolin
