3D model of vandragon_de
The models were repaired and checked for printability.
A container or cargo ship belongs to every bath tub fleet. I once drew a small and
...Показать больше
a particularly large version. The swimming characteristics are still very good even when fully loaded.
Have fun printing :)
Even if my boats are not benchmarks (benchy), you can use them for quality control.
Although it is a lot of fun to draw boats and bring them to life, it takes a lot of time to research and draw. Especially the 1:1000 scale models are very time-consuming.
Printer brand:
Prusa
Printer:
i3 MK2S
Rafts:
No
Supports:
No
Resolution:
0,2
Infill:
35% and 10%
Notes:
The infill must be printed obliquely
The lower section has 35% infill, the upper 10%. For this purpose I have extended the surface layer to 6.
Multicolour was made possible by changing the filaments. As always with my Prusa and Slic3r, an M600 command was simply inserted in the appropriate places.
Dark red leaves layer - 0 - 9mm (Layer 0-45)
Green from - 9-19.8mm (Layer 45-99)
White from - 19.8mm - END (Layer 99-292)
https://www.instagram.com/vandragon_de
