3D model of uwcharlie1983. The models were repaired and checked for printability.
This a weighted poker card capper. It is placed on your hole cards during a hand
...Показать больше
to make sure they are not accidentally folded. The base is designed with the same diameter (39mm) as a standard size poker chip so this will stack perfectly on your chips when not in use.
This design is the Portland Trail Blazers logo that was updated in 2017.
--- Printing ---
1) Print the logo file twice. Make sure you print it with the tabs up.
2) I printed the holder (upside down) and base with line support material spaced at 4.5mm.
--- Assembly ---
1) The holder is designed to have 4 nickels placed inside of it as ballast prior to assembly.
2) The four pieces will slide/snap together.
3) Put a little adhesive in the slots in the base before pressing the two logo pieces into the base. The holder should snap in and stay, but I use a little adhesive just to make sure.
Printer brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
No
Resolution:
0.1 mm
Infill:
10%
