Shown with the pin and bearings rings that are used in the fence assembly, to give a real world reference that the part is sized correctly to the mm and works with
...Показать больше
other corresponding parts.
I built this part because other replacement parts for this table saw fence lever were slightly longer than the original, and therefore did not work with smaller print beds. After attempting to customize an existing one with a "remix" version with a shorter handle, I decided to just start from scratch and build my own. Using the original broken part, which I have pictured in the image gallery, I was able to construct this one, with a more comfortable, easier to hold grip, and some additional stress supports.
**PROS:**
* Prints on a smaller print bed
* More comfortable to handle
* Some added component support
**CONS:**
* Uses more filament than other options (_based on your slicer preferences, mine are listed below for my "Parts Profile"_)
* Takes longer to print
